Home › Mudjacking
Mudjacking — and its lighter cousin, polyurethane foam lifting — raise a sunken slab back to level by pumping material through small holes. In the Huntsville area a typical lift runs $600–$2,500. If your garage floor, patio, or interior slab has dropped on red clay or young fill, a vetted local pro can tell you in a free inspection whether a lift is enough or whether the house needs piers.
Mudjacking Huntsville is the slab-leveling job after soil washes out or the clay at the edge dries and shrinks.
A slab fails quietly from below. Soil washes out, fill consolidates, or the clay at the edge dries and shrinks, and the concrete follows it down. Mudjacking drills a pattern of small holes and pumps a cement-based slurry under the low area until the slab comes back toward level. Foam lifting does the same job with expanding polyurethane that weighs almost nothing and cures in minutes.
Neither method is a foundation replacement. They restore grade when the concrete is still in one piece and the ground has mostly stopped moving. The slab foundation repair guide puts lifting next to pier work; this page is the lifting half in detail.
If doors are racking, brick is stair-stepping, and a whole corner of the house is going with it, skip straight to helical piers. A lift under a still-moving footing is money spent twice.
Both work. The soil under your lot decides which one is honest.
| Mudjacking (slurry) | Polyurethane foam | |
|---|---|---|
| Material | Cement, soil, and water mix | Expanding structural foam |
| Weight | Heavy — can re-load weak clay | Very light |
| Holes | About 1–2 inches | Smaller ports |
| Cure / traffic | Hours to a day | Often same afternoon |
| Typical range here | $600 – $2,500 for a residential section | |
Typical ranges from published national cost guides, reviewed August 2026. Area, thickness, and access change the number. Your quote from a free inspection may differ.
On North Alabama's soft, wet red clay — especially after a soaked February or a washed-out downspout line — many crews prefer foam because the slurry's extra weight can push the same weak soil farther down. Mudjacking still wins on thick exterior slabs and when budget is the constraint. Ask the inspector to say which they would put under your slab and why.
Madison, Harvest, Meridianville, and east Athens grew on graded farmland. A lot of those slabs sit half on cut and half on fill. Fill keeps consolidating for years after closing, which is why a five-year-old house can develop a lean before the neighborhood looks "old." Under the fill is expansive red clay that swells through wet winters and shrinks through dry Augusts, so the unprotected edge of a slab drops faster than the middle. Poor gutter discharge makes the cycle sharper. And in parts of Madison and Limestone counties, limestone karst underneath can leave a soft spot no surface lift will hold — that is a pier conversation, not a mudjacking one.
Water management is half the repair. A lift that does not also move roof water away from the slab is a temporary cosmetic. The waterproofing guide covers drainage; the cost guide puts a $600–$2,500 lift next to $1,000–$3,000 piers so you can see which problem you actually have.
A vetted local pro will measure the drop, say whether mudjacking, foam, or piers is the honest fix, and hand you a written price — no obligation, usually starting with a callback within one business hour.
Request My Free InspectionTypically $600–$2,500 for a sunken residential section. Larger interior slabs sit higher in that band. Published ranges only; the free inspection is the real number.
Foam is often the better pick on soft, wet red clay because it adds almost no weight. Slurry is cheaper and proven on thick exterior slabs. The inspector should choose for the soil, not the catalog.
A sound house slab that has dished — and whose soil has stopped moving — can be lifted. A still-dropping corner needs helical or push piers.
Years, if water is also fixed. If downspouts still soak the clay beside the slab, the same section can drop again.
Small ones, patched after the lift. Foam uses smaller ports than slurry. Most jobs finish in a day.
Tell us which slab dropped and by about how much. A vetted pro covering Huntsville, Madison, and the Tennessee Valley calls you back fast.